Accueil > Réseau > How to Enable IP Forwarding in Linux

How to Enable IP Forwarding in Linux

19/11/2016 Categories: Réseau Tags: , ,
Print Friendly

ip forwarding linuxBy default any modern Linux distributions will have IP Forwarding disabled. This is normally a good idea, as most peoples will not need IP Forwarding, but if we are setting up a Linux router/gateway or maybe a VPN server (pptp or ipsec) or just a plain dial-in server then we will need to enable forwarding. This can be done in several ways that I will present bellow.

Check if IP Forwarding is enabled

We have to query the sysctl kernel value net.ipv4.ip_forward to see if forwarding is enabled or not: Using sysctl:

sysctl net.ipv4.ip_forward
net.ipv4.ip_forward = 0

or just checking out the value in the /proc system:

cat /proc/sys/net/ipv4/ip_forward

As we can see in both the above examples this was disabled (as show by the value 0).

Enable IP Forwarding on the fly

As with any sysctl kernel parameters we can change the value of net.ipv4.ip_forward on the fly (without rebooting the system):

sysctl -w net.ipv4.ip_forward=1


echo 1 > /proc/sys/net/ipv4/ip_forward

the setting is changed instantly; the result will not be preserved after rebooting the system.

Permanent setting using /etc/sysctl.conf

If we want to make this configuration permanent the best way to do it is using the file /etc/sysctl.conf where we can add a line containing net.ipv4.ip_forward = 1

net.ipv4.ip_forward = 1

if you already have an entry net.ipv4.ip_forward with the value 0 you can change that 1.

To enable the changes made in sysctl.conf you will need to run the command:

sysctl -p /etc/sysctl.conf

On RedHat based systems this is also enabled when restarting the network service:

service network restart

and on Debian/Ubuntu systems this can be also done restarting the procps service:

/etc/init.d/ restart

Using distribution specific init scripts

Although the methods presented above should work just fine and you would not need any other method of doing this, I just wanted to note that there are also other methods to enable IP Forwarding specific to some Linux distributions. For example Debian based distributions might use the setting:


set it to yes and restart the network service. Also RedHat distributions might set this using:


and again restart the network service.

Regardless the method you have used once you have completed this you can check it out using the same method shown above:

sysctl net.ipv4.ip_forward
net.ipv4.ip_forward = 1

cat /proc/sys/net/ipv4/ip_forward

If the result is 1 then the Linux system will start forwarding IP packets even if they are not destined to any of its own network interfaces.

Les commentaires sont fermés.